Engineering, 16.12.2021 04:50 monacelli21212owlrlu
What is the total magnification of the specimen if the ocular lens is 10x and objective lens is 200x
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
What is the total magnification of the specimen if the ocular lens is 10x and objective lens is 200x...
Questions
History, 26.09.2019 14:10
Biology, 26.09.2019 14:10
Physics, 26.09.2019 14:10
English, 26.09.2019 14:10
Mathematics, 26.09.2019 14:20
Social Studies, 26.09.2019 14:20
English, 26.09.2019 14:20
Social Studies, 26.09.2019 14:20
Mathematics, 26.09.2019 14:20
Mathematics, 26.09.2019 14:20
Biology, 26.09.2019 14:20
