Engineering, 12.03.2022 14:00 shay68596
It has been established that a hole to be tapped must be smaller than the desired thread
diameter. For example: a 5/16" hole must be drilled for a 3/8-16UNC thread. How much
larger must a shaft be machined to receive a 3/8-16UNC external thread? Why?
Answers: 3
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
It has been established that a hole to be tapped must be smaller than the desired thread
diameter....
Chemistry, 17.03.2021 23:40
English, 17.03.2021 23:40
Advanced Placement (AP), 17.03.2021 23:40
Mathematics, 17.03.2021 23:40
Mathematics, 17.03.2021 23:40
English, 17.03.2021 23:40
Mathematics, 17.03.2021 23:40
Chemistry, 17.03.2021 23:40