subject
Engineering, 01.04.2022 14:30 xojade

Consider a 10 x 10^6 m3 lake fed by a polluted stream having a flow rate of 5.0 m3
/s and pollutant
concentration equal to 10 mg/l. There is also a sewage outfall that discharges 0.5 m3
/s of
wastewater having a pollutant concentration of 100 mg/L. The stream of sewage wastes have a
decay rate coefficient of 0.20 / day.
a) Assuming the pollutant is completely mixed in the lake and assuming to evaporation or
other water losses or gains, find the steady-state pollutant concentration in the lake.
b) The sewage discharge was eliminated as a source of pollution. The incoming stream still has
flow Qs= 5 m3
/s and concentration Cs= 10 mg/L. To solve the problem, find the new final
steady-state concentration. Assuming complete mix conditions, find the concentration of
pollutant in the lake on week after the diversion.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 04.07.2019 18:10
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
question
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
You know the right answer?
Consider a 10 x 10^6 m3 lake fed by a polluted stream having a flow rate of 5.0 m3
/s and po...
Questions
question
Physics, 29.12.2020 23:10
question
Mathematics, 29.12.2020 23:10
Questions on the website: 13722367