History, 05.05.2020 09:27 guitarherolds

In a short paragraph explain why GDP measures and why GDP per capita is such an important way to measure a countries level of the development why countries with high GDP is usually considered a more developed

Answers: 2

Show answers

Another question on History

History, 21.06.2019 22:30

What’s the term used for a lawyer who argues for the convection for a defendant in a criminal case?

Answers: 1

Answer

History, 22.06.2019 00:00

Which of the following is true about a merger? a. it is an example of deregulation. c. it is a combination of two or more companies into a single firm. b. it violates the sherman anti-trust act of 1890. d. it always leads to economic growth.

Answers: 2

Answer

History, 22.06.2019 11:40

What was used by federalists to ratify the constitution?

Answers: 2

Answer

History, 22.06.2019 13:50

Which did president andrew jackson support?

Answers: 1

Answer

You know the right answer?

In a short paragraph explain why GDP measures and why GDP per capita is such an important way to mea...

Questions

Physics, 14.09.2019 02:30

If a body travels half its total path in the last 1.50 s of its fall from rest, find the total time of its fall (in seconds)....

Engineering, 14.09.2019 02:30

What is the heat capacity rate? what does a heat capacity of infinity for a fluid in a heat exchanger means?...

Physics, 14.09.2019 02:30

An electron is travelling in a straight line with a kinetic energy k = 1.60 x 10^-17j. what are (a) the magnitude and (b) the direction of the electri...

Engineering, 14.09.2019 02:30

Water at 20 degree celsius enters a 4cm o. d tube 4m long and is heated by stream condensing on the outside of the tube. if the water flow rate is 10/...

Engineering, 14.09.2019 02:30

Elaborate on the steps required to specify problems in heat transfer....

Engineering, 14.09.2019 02:30

Define elements necessary for establishing symmetry when solving heat transfer problems....

Engineering, 14.09.2019 02:30

Describe the physics associated with the concept of thermal resistance....

Engineering, 14.09.2019 02:30

For the stress obtained in the previous question, what exactly is this value referring to?...

Engineering, 14.09.2019 02:30

Draw a schematic of the lift off process for the diferent resist profiles....

Engineering, 14.09.2019 02:30

Briefly describe the operation and use of strain gauges...

Engineering, 14.09.2019 02:30

An insulated open feedwater heater (mixing box) is used in a steam power plant to raise the temperature of the water going into the boiler which incre...

Engineering, 14.09.2019 02:30

How is the principle of superposition used to determine the stress state for a combined loading?...

Engineering, 14.09.2019 02:30

Explain what happens chemically to positive and negative photoresist when exposed to uv radiation....

Engineering, 14.09.2019 02:30

How does fouling affects the performance of a heat exchanger?...

Engineering, 14.09.2019 02:30

Acoca cola can with a diameter of 65 mm and wall thickness of 400 μm has an intemal pressure of s0 kpa. calculate the principal stresses at a point on...

Engineering, 14.09.2019 02:30

Which of the following describes fibers? a)- single crystals with extremely large length-to-diameter ratios. b)- polycrystalline and amorphous materi...

Engineering, 14.09.2019 02:30

List four major factors in which ic technology differs from mems or miniaturization science....

Engineering, 14.09.2019 02:30

Astrain gauge with a 5 mm gauge length gives a displacement reading of 1.25 um. calculate the stress value given by this displacement if the material...

Engineering, 14.09.2019 02:30

What is the governing ratio for thin walled cylinders?...

Engineering, 14.09.2019 02:30

What is the significance of saint venant's principle?...

More questions: History Another questions