Acylinder is sliced parallel to its base. what shape is formed?

Circle. The base of a cylinder is a circle and it is sliced parallel to the base.

If you slice a cylinder at an angle parallel to its base (the flat surfaces on both ends), then you will be left with two smaller cylinders with the same base but different heights. Another way to think of it is if you cross-section cut (cut it parallel to its base/end) a rolling pin in half, you now have essentially two shorter rolling pins. Hope this helps!

(0,-3) see attached graph

step-by-step explanation:

a. to solve the system, graph the two equations.

x = y+3 becomes y=x-3 has m=1/1 and b=-3. start at (0,-3) on the y-axis and plot a point. then move up 1 unit and 1 unit to the right. plot a point and connect.

y=-4x+3 has m =-4/1 and b=-3. start at (0,-3) on the y-axis and plot a point. then move down four units and to the right 1 unit. plot a point and connect.

the solution is the point (x,y) where the two lines intersect. by the graph below it is (0,-3).

b. to solve by substitution, substitute y = -4x-3 into x= y+3

x= (-4x-3) +3

x=-4x

5x=0

x=0

now substitute x = 0 back in to find y.

y= -4(0)-3

y=0-3

y=-3

solution is (0,-3)

c. use elimination by adding the equations together.

x-y=3

4x+y=-3

5x=0

x=0

then substitute into one equation to find y.

y=-4(0)-3

y=-3