Mathematics, 26.08.2020 18:01 judt3500

Consider the equation 3p – 7 + p = 13. What is the resulting equation after the first step in the solution? p – 7 = 13 – 3p
2p – 7 = 13
3p – 7 = 13 – p
4p – 7 = 13

Answers: 1

Show answers

Another question on Mathematics

Mathematics, 21.06.2019 16:00

You are measuring the dimensions of the floor in your bedroom because you are planning to buy new carpet. which unit of measure is the most appropriate to use in this situation?

Answers: 3

Answer

Mathematics, 21.06.2019 18:00

Need on this geometry question. explain how you did it.

Answers: 1

Answer

Mathematics, 21.06.2019 18:30

Divide. write in simplest form 41/6 divided by 10

Answers: 1

Answer

Mathematics, 21.06.2019 23:00

Ineed to know the ordered pairs for this equation i need the answer quick because it’s a timed test

Answers: 1

Answer

You know the right answer?

Consider the equation 3p – 7 + p = 13. What is the resulting equation after the first step in the so...

Questions

Engineering, 26.07.2019 19:20

A0.7 m^3 rigid tank contains refrigerant-134a initially at 200 kpa and 40% quality. heat is now transferred to the refrigerant until the pressure reac...

Engineering, 26.07.2019 19:20

Solid rockets can experience significant 2 phase flow. a) true b) false...

Engineering, 26.07.2019 19:20

Burn rate can be affected by: a. variations in chamber pressure b. variations in initial grain temperature c. gas flow velocity d. all of the above...

Engineering, 26.07.2019 19:20

Burn rate is a key parameter that drives the performance of a solid rocket motor. a) true b) false...

Engineering, 26.07.2019 19:30

In the fully-developed (hydrodynamically and thermally) region of a flow in a circular tube a) the velocity at any radial position does not change alo...

Engineering, 26.07.2019 19:30

Arigid 10 l vessel initially contains a water at 100°c with 25% quality. the mixture is then heated until its temperature is 250°c. find the initial a...

Engineering, 26.07.2019 19:30

Arigid tank initially contains 2 kg of steam at 500 kpa and 350°c. the steam is then cooled until it is at 100°c. determine the final pressure and the...

Engineering, 26.07.2019 19:30

Proper grain stress/strain analysis is required in solid motor design: a. to ensure good motor structure b. to avoid surface cracks c. to avoid bond...

Mathematics, 26.07.2019 19:30

Apoliceman shoots a bullet into the air from a height of 10 feet with an initial vertical velocity of 160 feet per second. use the vertica...

Engineering, 26.07.2019 19:30

Specific impulse of a solid rocket motor can be calculated using average thrust because thrust is not time dependent for solid motors. a) true b) fals...

Engineering, 26.07.2019 19:30

Consider a laminar oil flow in a tube, the hydrodynamic entry length is entry length. a) larger than the thermal b) shorter than c) comparable with...

Engineering, 26.07.2019 19:30

In solid motors, htpb and pban are two common types of plasticizers. a) true b) false...

Engineering, 26.07.2019 19:30

Oil is cooled down from 140°c to 70°c in a parallel flow heat exchanger using cold liquid water. the water flow is heated from 10 °c to 40°c. calculat...

Engineering, 26.07.2019 19:30

Alarge flat plate is dissipating heat uniformly through its top surface due to the embedded heaters. air at 20°c is flowing over the top surface, whil...

Engineering, 26.07.2019 19:30

If the velocity of a flow over a flat plate is increased four times, and the flow remains in the laminar regime, with all other properties remaining t...

Engineering, 26.07.2019 19:30

In solid rocket motor terminology, a sliver is: a. a basic geometric shape b. leftover propellant c. a test article for propellant characterization d...

Engineering, 26.07.2019 19:30

Afacility is equipped with a wind tunnel, and can measure the friction coefficient for flat surfaces and airfoils. with the measured friction data, on...

Engineering, 26.07.2019 19:30

Water at 70f flows at 90 ft3/min along a 1200 ft section of a 6 inch diameter smooth steel pipe. find the resulting pressure head developed by this fl...

Biology, 26.07.2019 19:30

Science--a shark, a crab and a shrimp find themselves in hypoxic conditions. who do you think is most likely to survive a dead zone? select one: a....

Biology, 26.07.2019 19:30

Science--an excess of which of the following would most likely be associated with formation of a dead zone? select one: a. carbon b. oxygen c. nitro...

More questions: Mathematics Another questions

Consider the equation 3p – 7 + p = 13. What is the resulting equation after the first step in the solution? p – 7 = 13 – 3p 2p – 7 = 13 3p – 7 = 13 – p 4p – 7 = 13

Answers

Another question on Mathematics

Consider the equation 3p – 7 + p = 13. What is the resulting equation after the first step in the solution? p – 7 = 13 – 3p
2p – 7 = 13
3p – 7 = 13 – p
4p – 7 = 13