A process engineer has defined the control limits for this process as three standard deviations above and below the mean, meaning that if a lot of measurements suddenly appear outside these limits, the process is out of control. Ideally, these control limits are within the product specification limits. For this product, the specification limits are 0.260 μm and 0.340 μm. If a width does not fall between these values, the chip fails testing and is destroyed. What are the control limits for this process?

the simplified form is

step-by-step explanation:

we want to simplify the expression,

let us change the middle bar to a normal division sign to obtain,

we multiply the first fraction by the reciprocal of the second fraction to obtain,

we factor to obtain,

we cancel the common factors to get,

we simplify to get,

the correct answer is b

answer: yard ramps with a level off platform are typically 36 feet long. truck, rather than at an angle, enabling access to those pallets at the very back of the truck. if you are using your yard ramp to convert a loading dock into a drive-in door, we even at 60 inches (5 feet) high and a 30 foot ramp, the slope of the ramp will be less

step-by-step explanation:

what is the answer to this