Mathematics, 19.11.2020 06:10 alexander1093
A set of plans shows that an opening in a bulkhead is needed for a section of pipe to pass through. The plans show metric values, but the only tape measure available is marked in inches. The pipe is shown as a size DN80 (a European pipe-sizing standard), and a chart indicates the outside diameter of DN80 pipe is 88 millimeters (mm). According to the plans, all openings must be 40 mm larger than the pipe. You know that 25.4 mm is equal to one inch. What is the diameter of the needed opening in inches? Round your answer to the nearest whole inch.
Answers: 3
Mathematics, 21.06.2019 19:30
Which of the following describes the symmetry of the graph of y = x3?
Answers: 2
Mathematics, 21.06.2019 21:30
Amachine part consists of a half sphere and a cylinder, as shown in the figure. the total volume of the part is π cubic inches.
Answers: 1
Mathematics, 21.06.2019 21:30
50 people men and women were asked if they watched at least one sport on tv. 20 of the people surveyed are women, but only 9 of them watch at least one sport on tv. 16 of the men watch at least one sport on tv. make a a two-way table and a relative frequency table to represent the data.
Answers: 3
Mathematics, 21.06.2019 22:30
Nicole is making carrot bread she needs 5 cups of carrots for 2 cups of sugar.what is the ratio of cups of sugar to cups of carrots that nicole will need? write the ration in three different ways
Answers: 1
A set of plans shows that an opening in a bulkhead is needed for a section of pipe to pass through....
Biology, 09.10.2019 20:30
Mathematics, 09.10.2019 20:30
History, 09.10.2019 20:30
Mathematics, 09.10.2019 20:30
History, 09.10.2019 20:30
Physics, 09.10.2019 20:30
Mathematics, 09.10.2019 20:30