One label on a package of bolts says that each bolt has a diameter of 0.45 inch. To be in the package, the percent error of the diameter must be less than 4%. A test on the production line shows a bolt with a diameter of 0.43 inch. Should this bolt go into the package?​

Step-by-step explanation:

The diameter is 0.45 in

The percent error is < 4%

The lower limit of allowance is:

Less than 4% error means the diameter should be greater than 0.432 in.

The bolt with the diameter 0.43 in is outside of the allowance and should not go into the package

1,589.63 in.^3

step-by-step explanation:

i hope this you : d

when rotating a figure 180 degrees, imagine that you are able to take the figure and turn it clockwise or counterclockwise around a center point. to rotate a figure 180 degrees, you will need to apply the rule (x, y) → (-x, -y). start by using a coordinate grid with coordinates for each vertex of the figure. the center point of the coordinate grid is located at (0, 0), which is what you will rotate the figure around. write down the original coordinates of the shape you are going to rotate. then, apply the rule. for example, coordinate (1, 2) becomes (-1, -2). another example would be, coordinate (-4, -2) becoming (4, 2). after you change each original coordinate to the rotated coordinate, you will draw your new figure.

step-by-step explanation: