subject

Mathematics, 18.03.2021 02:20 PrestonTB

A group has $478 to spend on play tickets that cost 9$? how many tickets can the group buy? how did you interpret the remainder

ansver

Answers: 2

Show answers

Another question on Mathematics

question

Mathematics, 21.06.2019 17:40

How can the correlation in the scatter plot graph below best be described? positive correlation negative correlation both positive and negative no correlation

Answers: 1

question

Mathematics, 21.06.2019 20:00

Suppose a store sells an average of 80 cases of soda per day. assume that each case contains 24 cans of soda and that the store is open 10 hours per day. find the average number of soda that the store sells per hour.

Answers: 1

question

Mathematics, 21.06.2019 21:30

Having a hard time understanding this question (see attachment).

Answers: 2

question

Mathematics, 21.06.2019 22:00

The serenity and the mystic are sail boats. the serenity and the mystic start at the same point and travel away from each other in opposite directions. the serenity travels at 16 mph and the mystic travels at 19 mph. how far apart will they be in 3 hours?

Answers: 1

You know the right answer?

A group has $478 to spend on play tickets that cost 9$? how many tickets can the group buy? how did...

Questions

question

History, 13.09.2019 23:30

3. the founders of massachusetts were a enslaved people cindentured servants b plantation owners d religious dissenters...

question

Biology, 13.09.2019 23:30

Which of the following is a difference between mitotic cell division in animals and in plants....

question

Physics, 13.09.2019 23:30

How does increasing the speed of a motorbike change the amount of energy in its kinetic energy store?...

question

Mathematics, 13.09.2019 23:30

What is (f ° g)(2) and (g ° f)(2) with the set of points f: {(0,4), (1,2), (2,0), (3,2), (4,4)} and g: {(0,4), (1,3), (2,2), (3,1), (4,0)}...

question

Social Studies, 13.09.2019 23:30

Which of the following architectural elements was perfected by the romans and enabled them to build large public buildings such as the pantheon ?...

question

Engineering, 13.09.2019 23:30

Asteam power plant operates between the pressure limit of 3.0 mpa for the boiler and 50 kpa for the condenser. if the plant operates in an ideal ranki...

question

Engineering, 13.09.2019 23:30

The flight test data for a given airplane refer to a level-flight maximum-velocity run made at an altitude that simultaneously corresponded to a press...

question

Engineering, 13.09.2019 23:30

Aresidential heat pump has a coefficient of performance of 1.49 how much heating effect, in kj/h, will result when 4 kw is supplied to this heat pump?...

question

Engineering, 13.09.2019 23:30

Amass of 5.5 kg of saturated liquid-vapor mixture of water is contained in a piston-cylinder at 101.325 kpa. initially, 2.3 kg of the water is in the...

question

Engineering, 13.09.2019 23:30

Phase difference is: select one: 1. the angle difference of a point on waveform from the origin 2. the angle between points of three time wave forms...

question

Engineering, 13.09.2019 23:30

Amixture of gases consists of 0.4 kg of oxygen, 0.7 kg of carbon dioxide, and 0.2 kg of helium. this mixture is maintained at 100 kpa and 27°c. determ...

question

Engineering, 13.09.2019 23:30

Phase difference measurement is possible using: select one: 1. accelerometers 2. data collectors 3. dual channel analysers 4. velocity pickups 5. li...

question

Engineering, 13.09.2019 23:30

Asteam power plant operates on the ideal reheat rankine cycle. steam enters the high-pressure turbine at 8 mpa and 600 oc and leaves at 3 mpa. steam i...

question

Engineering, 13.09.2019 23:30

Imagine you were hired by an insurance company to determine the agma rating of a pinion in a failed gearbox. the pinion is cut to a pressure angle of...

question

Engineering, 13.09.2019 23:30

An alloy was examined under the microscope, and the following image produced. determine: a) the average grain size of the alloy. b) the yield strengt...

question

Engineering, 13.09.2019 23:30

Explain why annealing is important in metal processing. provide and example. discuss the different types of annealing and associated microstructural c...

question

Engineering, 13.09.2019 23:30

Explain the two advantages and the two disadvantages of fission as an energy source....

question

Engineering, 13.09.2019 23:30

Amissile flying at high speed has a stagnation pressure and temperature of 5 atm and 598.59 °r respectively. what is the density of air at this point?...

question

Engineering, 13.09.2019 23:30

Aluminium alloys tend to get their strength from precipitation hardening, work hardening and solute hardening. what can you infer about the hall-petch...

question

Engineering, 13.09.2019 23:30

Asteam power plant operates on an ideal regenerative rankine cycle with one open feedwater heater operating at 0.125 mpa. steam enters the first turbi...

More questions: Mathematics Another questions

Questions on the website: 13722362