A wind turbine has blades 50m in diameter and an overall height (to the highest point) of 125m. If it has four blades instead of three, create four equations modelling the height of a point on the tip for each of the four blades.

Blade A : H(θ) = 75 + 50 sin θ

Blade B : H(θ) = 75 + 50 sin(θ + 90° )

Blade C : H(θ) = 75 + 50 sin( θ + 180° )  

Blade D : H(θ) = 75 + 50 sin( θ + 270° )

Step-by-step explanation:

Given data :

Diameter of blade = 50 m

overall height = 125 m

The four blades : Blade A , Blade B, Blade C, Blade D  all moves in same direction hence they make 90° to each other.

Lets assume The blades are standing at  θ with the horizontal

The four equation  modelling the heights :

Blade A : H(θ) = 75 + 50 sin θ

Blade B : H(θ) = 75 + 50 sin(θ + 90° )

Blade C : H(θ) = 75 + 50 sin( θ + 180° )  

Blade D : H(θ) = 75 + 50 sin( θ + 270° )

to plot points   for x just start at the origin (middle) and go to the left however many times it say(if the number is a positive) if the number is a negative then go right however many times it says if it is 0 go nowhere

now keep you pencil there and go up however many times it says on y(if it is positive) if it is negative then go down however many times it says. if it says 0 go nowhere.

you have just plotted a point! now when you finish plotting all of them connect them with a ruler

plot each point as (-3, 7), (0,4), (3,1), (8,-4)   in the parenthesis on the left of the comma is x and the right is y.