Physics, 20.07.2019 20:00 montanolumpuy

Amotorboat approaches you head-on and sounds two shorts blasts. you would prefer to pass the boat on your port (left) side. which sound signal should you use to indicate your disagreement? eleven prolonged blasts

Answers: 1

Show answers

Answers

Answer from: lelseymota123

Explanation:

Sound signals used in waterways are a mode of communication with the other boaters to avoid any confusion and avoid collisions.

In order to show that we disagree with the other boater decision, the sound signal to blow is five or more short blast. This will give an impression to the other boater that I have not agreed with his decision.

The sound signal that I will give the other boater to inform him that I wish him to pass his boat on my left side is one short blast. This will tell him to pass on my left side.

Answer from: xmhllo

The sound signal you should use to indicate you disagree with other boaters intentions is five or more short blasts

Five or more short blast shows a danger signal. They are signals used to indicate disagreement. They are one of the types of sound signals that show you are not in agreement with other boater’s intention.

Further Explanation

Sound signals are also known as blasts. There are 2 common sound signals, short blast and prolonged blast. They are used when two vessels are heading towards each other.

Although these types of sound signals cannot be used in conditions that affect visibility such as fog.

However, there are different sound signals combinations and it is very important for all boaters to understand what each of the sound signals means.

The short blast is just 1 seconds while the prolonged blast lasts for duration of 4-6 seconds.

Sound signals can actually mean a change in direction to other boaters, it has different meanings.

One short blast indicate that you are informing other boaters you want to pass them from your port side (left-hand side), prolonged blasts means you are informing other boaters you want to pass them from starboard side (right-hand side) and three shorts blast means you are informing other boaters you are operating astern propulsion

LEARN MORE:

sound signal

KEYWORDS:

prolonged blastsound signalsshort blastboatersvessels

Answer from: Quest

a.) travels faster in solids because the particles are closer together.

air is a gas water is a liquid

Answer from: Quest

The duration of a photographic flash is related to an rc time constantly

Another question on Physics

Physics, 22.06.2019 04:00

Amodel rocket with a mass of 0.212 kg is launched into the air with an initial speed of 84 m/s. how much kinetic energy will the rocket have at a height of 214 m? assume there is no wind resistance. 634 j 303 j

Answers: 2

Answer

Physics, 22.06.2019 14:20

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.

Answers: 1

Answer

Physics, 22.06.2019 16:20

Select the correct answer. what does the process of natural selection involve?

Answers: 1

Answer

Physics, 22.06.2019 18:50

8.29 two streams containing pyridine and acetic acid at 25°c are mixed and fed into a heat exchanger. due to the heat-of-mixing effect, it is desired to reduce the temperature after mixing to 25°c using a stream of chilled ethylene glycol as indicated in the diagram. calculate the mass flow rate of ethylene glycol needed. the heat capacity of ethylene glycol at these conditions is approximately 2.8 kj/(kg k), and the enthalpy change of mixing (δmixh) is given below.

Answers: 3

Answer

You know the right answer?

Amotorboat approaches you head-on and sounds two shorts blasts. you would prefer to pass the boat on...

Questions