subject
Physics, 19.07.2019 23:00 anjali1097

You are trying to induce a current and have put together the setup shown. what needs to be added in order for current to flow in the wire?

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 22:50
Calculate the heat capacity per object when the total energy is 4 quanta. (think of this in terms of increasing from 3.5 quanta of energy in the system to 4.5 quanta of energy in the system, if that were possible.) c4 = __ j/k/object
Answers: 2
question
Physics, 22.06.2019 00:30
Imagine you work as a consultant, and your daily job involves listening to the constructive criticism of others. as part of your job, you must listen to opposing viewpoints to make important decisions. in this activity, you are a consulting dam engineer. you must make a decision about four different dams; should they be repaired, taken down, or left alone? you will listen to contrasting opinions about what should be done with the dams before you make the final decision. as the consulting dam engineer, what do you decide to do with this dam? explain your reasoning. by making your decision, did you support the opinions of the mayor and/or the dam safety official? why or why not? (site 1)
Answers: 1
question
Physics, 22.06.2019 01:30
Ablock of mass 1.5 kg slides down an inclined plane that has an angle of 15. if the inclined plane has no friction and the block starts at a height of 3 m, how much kinetic energy does the block have when it reaches the bottom? acceleration due to gravity is g = 9.8 m/s2. a. 6.8 j b. 50.9 j c. 0 j d. 44.1 j
Answers: 1
question
Physics, 22.06.2019 05:10
Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.
Answers: 3
You know the right answer?
You are trying to induce a current and have put together the setup shown. what needs to be added in...
Questions
question
Mathematics, 13.12.2021 22:10
question
Chemistry, 13.12.2021 22:10
question
Mathematics, 13.12.2021 22:10
question
Mathematics, 13.12.2021 22:10
question
Mathematics, 13.12.2021 22:10
Questions on the website: 13722367