Physics, 10.07.2019 01:30 ramirez5571

Suppose you saw a waxing gibbous moon. what phase would you expect one week later?

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 02:00

In which situation has the independent variable for the experiment been changed? check all that apply. changed from counting the number of duckweed at day 0 and day 14 to counting them every day changed from testing duckweed growth in beakers to testing duckweed growth in large outdoor tanks changed from testing the effect of ph on duckweed growth to testing the effect of light levels on duckweed growth changed from testing the effect of acid ph on duckweed growth to testing the effect of basic ph on duckweed growth

Answers: 1

Answer

Physics, 22.06.2019 10:20

Assume that a person skiing high in the mountains at an altitude of h = 15100 ft takes in the same volume of air with each breath as she does while walking at sea level. determine the ratio of the mass of oxygen inhaled for each breath at this high altitude compared to that at sea level. assume that the air composition (i.e. % of air that is oxygen) is the same at sea level as it is at 15100 ft.

Answers: 2

Answer

Physics, 22.06.2019 10:50

Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.

Answers: 3

Answer

Physics, 22.06.2019 12:30

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question