Compare solids, liquids, and gases in terms of their shape and volumes.

Amachinist needs to remove a tight fitting pin of material a from a hole in a block made of material b. the machinist heats both the pin and the block to the same high temperature and removes the pin easily. what statement relates the coefficient of thermal expansion of material a to that of material b? a) the situation is not possible, heating block b will shrink the hole in the material as the material expands with increasing temperatureb) material b has the same coefficient of expansion as does material ac) material b has a negative coefficient of expansion and a has a positive coefficient of expansiond) material a has a greater coefficient of expansion than does material be) material b has a greate

First, launch the video below. you will be asked to use your knowledge of physics to predict the outcome of an experiment. then, close the video window and answer the question at right. you can watch the video again at any point. part a as in the video, we apply a charge +q to the half-shell that carries the electroscope. this time, we also apply a charge –q to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? view available hint(s) as in the video, we apply a charge + to the half-shell that carries the electroscope. this time, we also apply a charge – to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? it deflects more than it did at the end of the video. it deflects the same amount as at end of the video. it does not deflect at all. it deflects less than it did at the end of the video. submit

Use the profile illustrated for problem (1). assume that the layer of silty sand fill (sm) is placed over the entire site. estimate the thickness of the fill (h - in feet) that will cause the effective vertical stress at the center of the clay layer to increase by 517.5 pounds per square foot.