subject
Physics, 23.06.2019 01:30 kaylaamberd

The ideal gas model is valid if which of the following conditions is true? the gas density is low. the gas density is high. the temperature is low. the temperature is high. the gas density and the temperature are low. the gas density and the temperature are high. the gas density is high and the temperature is low. the gas density is low and the temperature is high.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 18:50
The summit of chimborazo, in ecuador, which is at a distance of about 6,384 km from the earth's center. the bottom of the mariana trench, in the western pacific ocean, which is nearly 6,370 km from the center of the earth. on the surface of earth on the equator line.
Answers: 1
question
Physics, 21.06.2019 19:30
A33.1 g copper object is launched from a 1.5 m 30° steel incline positioned on the floor by being pulled up a string attached to a 50.0 g mass suspended vertically over a pulley. the object is projected towards a glass table where it lands when it is at the point along its trajectory with the lowest speed. it comes to a halt when it clears the opposite edge of the table. it then falls and lands on 9 physics texts each 5 cm thick that are stacked on the floor on the opposite side of the table. assume that the table does not have a ledge and the rectangular object experiences 0.05 n of air resistance as it falls towards the books. how far and how long did the object travel and how fast does it hit the books. assume that at the moment the copper object leaves the incline, the massless string and ideal pulley break off
Answers: 2
question
Physics, 22.06.2019 07:00
We put a force of 50n on an object and the acceleration is 100 m/s². what is the mass of the object?
Answers: 1
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
The ideal gas model is valid if which of the following conditions is true? the gas density is low....
Questions
question
History, 11.10.2019 06:20
question
Mathematics, 11.10.2019 06:20
question
Mathematics, 11.10.2019 06:20
question
Social Studies, 11.10.2019 06:20
question
Mathematics, 11.10.2019 06:20
question
Mathematics, 11.10.2019 06:20
Questions on the website: 13722363