Physics, 21.11.2019 19:31 josuealejandro9632

(a) a child slides down a water slide at an amusement park from an initial height h. the slide can be considered frictionless because of the water flowing down it. can the equation for conservation of mechanical energy be used on the child?

(b) is the mass of the child a factor in determining his speed at the bottom of the slide?

(c) the child drops straight down rather than following the curved ramp of the slide. in which case will he be traveling faster at ground level?

following the curved ramp
dropping straight down
same speed in either case

(d) if friction is present, how would the conservation-of-energy equation be modified?

(e) find the maximum speed of the child when the slide is frictionless if the initial height of the slide is 11.5 m. (assume the child is initially at rest.) m/s

Answers: 3

Show answers

Answers

Answer from: vanessagomezcx

(a) Yes

Explanation: the slide is frictionless: this means that there are no non-conservative forces acting on the child, therefore the mechanical energy of the child is conserved.

The mechanical energy is sum of the kinetic energy (K) and the gravitational potential energy (U) of the child:

$E=K+U=\frac{1}{2}mv^2+mgh=const.$

where m is the mass of the child, v is his speed, g is the gravitational acceleration, h is his heigth above the ground.

(b) No

At the beginning of the motion of the child (highest point of the slide), the child is at rest, so its speed is zero: v=0, and all the mechanical energy is just potential energy:

E=U=mgh

where h is the height of the slide.

At the bottom of the slide, the height is zero: h=0, so all the mechanical energy has been converted into kinetic energy:

$E=K=\frac{1}{2}mv^2$

where v is the speed at the bottom of the slide. Since E is conserved, we can equalize the two equations, and we find an expression for v:

$\frac{1}{2}mv^2=mgh\\v=\sqrt{2gh}$

And we see that v does not depend on the mass of the child.

We can repeat the same procedure used in the previous part of the exercise, by using the conservation of energy, and we see again that the final speed of the child at ground level depends only on the height of the slide, h:

$v=\sqrt{2gh}$

Therefore, the child will be travelling at same speed.

(d) $mgh = \frac{1}{2}mv^2 + E_{wasted}$

If friction is present, the mechanical energy is no longer conserved, because part of the energy has been wasted because of the friction. The equation of conservation of energy would become:

$mgh = \frac{1}{2}mv^2 + E_{wasted}$

which means that the initial potential energy at the top of the ramp (mgh) has been converted only partially into kinetic energy ( $\frac{1}{2}mv^2$ ), while part has been wasted because of the frictional force ( $E_{wasted}$ ).

(e) 15.0 m/s

If we apply the formula found at point b), by using h=11.5 m, we can immediately find the speed of the child at the bottom in this situation:

$v=\sqrt{2gh}=\sqrt{2(9.8 m/s^2)(11.5 m)}=15.0 m/s$

Answer from: Quest

probably not the "magnets"in the magnet, so to speak, are thought to be electrons orbiting in shells. vurrent loops two sides to the loop

Answer from: Quest

as we probably am aware that our atmosphere or air have various levels, each level has different gasses, and each gas has another porousness. at the point when the light originates from lower porousness to higher penetrability, it alters its course. with the goal that implies that when the light originates from the moon to the earth, it alters it's course a lot more occasions. it essentially implies that the state of the light piece of the moon is changed on the earth.

not copied too! hope this !

joke:

h o h o hope you have a merry christmas!

Another question on Physics

Physics, 22.06.2019 11:30

If the textbook weighs 19.6 newtons on venus,what is the strength of gravity on venus?

Answers: 1

Answer

Physics, 22.06.2019 11:50

The scalar triple product computes the magnitude m of the moment of a force vector f about a specified line. it is m = (r × f) · n, where r is the position vector from the line to the point of application of the force and n is a unit vector in the direction of the line. use matlab to compute the magnitude m for the case where f = [12, −5, 4] n, r = [−3, 5, 2] m, and n = [6, 5, −7].

Answers: 3

Answer

Physics, 22.06.2019 19:00

Why do different substances have diffrent properties

Answers: 1

Answer

Physics, 22.06.2019 19:20

The dipole moment of the water molecule (h2o) is 6.17x10^-30 c.m. consider a water molecule located at the origin whose dipole moment p points in the +x-direction. a chlorine ion ( of charge-1.60x10^-19c , is located at x=3.00x10^-9m . assume that is much larger than the separation d between the charges in the dipole, so that the approximate expression for the electric field along the dipole axis can be used. a) find the magnitude of the electric force that the water molecule exerts on the chlorine ion. b) what is the direction of the electric force. -x-direction or +x-direction c) is this force attractive or repulsive?

Answers: 1

Answer

You know the right answer?

(a) a child slides down a water slide at an amusement park from an initial height h. the slide can b...

Questions