Physics, 27.11.2019 03:31 rileyallen4186pd5tgy

Amotor attached to a 120 v/60 hz power line draws an 8.40 a current. its average energy dissipation is 850 w. how much series capacitance needs to be added to increase the power factor to 1.0?

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 22:40

Consider two metallic rods mounted on insulated supports. one is neutral, the other positively charged. you bring the two rods close to each, but without contact, and briefly ground the the neutral rod by touching it with your hand. show answer correct answer what would be resulting charge (if any) on the initially neutral rod

Answers: 1

Answer

Physics, 22.06.2019 00:30

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Answers: 2

Answer

Physics, 22.06.2019 01:10

The 10-kg double wheel with radius of gyration of 125mm about o is connected to the spring of stiffness k = 600 n/m by a cord which is wrapped securely around the inner hub. if the wheel is released from rest on the incline with the spring stretched 225 mm, calculate the maximum velocity v of its center o during the ensuing motion. the wheel rolls without slipping

Answers: 1

Answer

Physics, 22.06.2019 07:50

The ratio of lift to drag l/d for a wing or airfoil is an important aerodynamic parameter, indeed, it is a direct measure of the aerodynamic efficiency of the wing. if a wing is pitched through a range of angle of attack, l/d first increases, then goes through a maximum, and then decreases. consider an infinite wing with an naca 2412 airfoil. estimate the maximum value of l/d. assume that the reynolds number is 9x10^6.

Answers: 2

Answer

You know the right answer?

Amotor attached to a 120 v/60 hz power line draws an 8.40 a current. its average energy dissipation...

Questions