Physics, 02.10.2019 01:30 kykylove1126

An engineer is working on a new kind of wire product that is about the size of a bacterium cell. which kind of technology is the engineer using?

nanotechnology
microtechnology
atomic technology
cellular technology

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 16:30

Aball bearing at 220.0 °c is dropped into a cup containing 250.0 g of water at 20.0 °c. the water and ball bearing come to a temperature of 30.0 °c. what is the heat capacity of the ball bearing in j/°c? (hint: how are the algebraic signs of q related for the ball bearing and the water? )

Answers: 1

Answer

Physics, 22.06.2019 00:30

Aball tossed vertically upward from the ground next to a building passes the bottom of a window 1.8 s after being tossed and passes the top of the window 0.20 s later. the window is 2.0 m high from top to bottom. what was the ball's initial velocity? the unit vector j^ is directed upward. how far is the bottom of the window from the launch position? how high does the ball rise above the launch position?

Answers: 1

Answer

Physics, 22.06.2019 02:50

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Answers: 3

Answer

Physics, 22.06.2019 06:00

Suppose water is leaking from a tank through a circular hole of area ah at its bottom. when water leaks through a hole, friction and contraction of the stream near the hole reduce the volume of water leaving the tank per second to cah 2gh , where c (0 < c < 1) is an empirical constant. a tank in the form of a right-circular cone standing on end, vertex down, is leaking water through a circular hole in its bottom. (assume the removed apex of the cone is of negligible height and volume.) (a) suppose the tank is 20 feet high and has radius 8 feet and the circular hole has radius 2 inches. the differential equation governing the height h in feet of water leaking from a tank after t seconds is dh dt = − 5 6h3/2 . if the height of the water is initially 8 feet, how long will it take the tank to empty? (round your answer to two decimal places.)

Answers: 2

Answer

You know the right answer?

An engineer is working on a new kind of wire product that is about the size of a bacterium cell. whi...

Questions