subject
Physics, 30.06.2019 05:20 joneil1952

What value did you calculate for the index of refraction of the acrylic block in part 2? how does your value compare to the accepted value of 1.50? calculate the percentage error. different materials have distinct indexes of refraction. explain how you might identify a material based on experiments like this one. mention at least one of the difficulties in identifying materials based on their indexes of refraction.

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 02:00
Chapter 23, problem 075 the figure shows a geiger counter, a device used to detect ionizing radiation (radiation that causes ionization of atoms). the counter consists of a thin, positively charged central wire surrounded by a concentric, circular, conducting cylindrical shell with an equal negative charge. thus, a strong radial electric field is set up inside the shell. the shell contains a low-pressure inert gas. a particle of radiation entering the device through the shell wall ionizes a few of the gas atoms. the resulting free electrons (e) are drawn to the positive wire. however, the electric field is so intense that, between collisions with gas atoms, the free electrons gain energy sufficient to ionize these atoms also. more free electrons are thereby created, and the process is repeated until the electrons reach the wire. the resulting "avalanche" of electrons is collected by the wire, generating a signal that is used to record the passage of the original particle of radiation. suppose the radius of the central wire is 24 Γ’Β΅m, the inner radius of the shell 2.3 cm, and the length of the shell 14 cm. if the electric field at the shell's inner wall is 2.8 Δƒβ€” 104 n/c, what is the total positive charge on the central wire?
Answers: 1
question
Physics, 22.06.2019 09:00
The pressure proportional to the area a- inversely b- directly c- increase d-decrease
Answers: 2
question
Physics, 22.06.2019 16:00
In which of the following is positive work done by a person on a suitcase
Answers: 1
question
Physics, 22.06.2019 23:00
Acommon technique in analysis of scientific data is normalization. the purpose of normalizing data is to eliminate irrelevant constants that can obscure the salient features of the data. the goal of this experiment is to test the hypothesis that the flux of light decreases as the square of the distance from the source. in this case, the absolute value of the voltage measured by the photometer is irrelevant; only the relative value conveys useful information. suppose that in part 2.2.2 of the experiment, students obtain a signal value of 162 mv at a distance of 4 cm and a value of 86 mv at a distance of 5.7 cm. normalize the students' data to the value obtained at 4 cm. (divide the signal value by 162.) then calculate the theoretically expected (normalized) value at 5.7 cm.
Answers: 2
You know the right answer?
What value did you calculate for the index of refraction of the acrylic block in part 2? how does y...
Questions
question
English, 05.06.2020 20:58
question
English, 05.06.2020 20:58
question
Mathematics, 05.06.2020 20:58
question
Mathematics, 05.06.2020 20:58
Questions on the website: 13722367