Physics, 05.07.2019 00:30 luividal37

Aspecimen of steel having an initial diameter of 0.503 in was tested in tension using a gauge length of 2 in. the following data were obtained for the elastic and plastic states 2-6 plastic state elastic state area a in? load p ibf elongation in load p ibf 0.1984 8 800 0.0004 1000 0.1978 9 200 0.0006 2000 0.1963 9 100 0.0010 3 000 0.1924 13 200 0.0013 4 000 0.1875 15 200 0.0023 7 000 0.1563 17 000 0.0028 8 400 0.1307 16 400 0.0036 8 800 0.1077 14 800 0.0089 9 200 note that there is some overlap in the data. (a) plot the engineering or nominal stress-strain diagram using two scales for the unit strain e, one scale from zero to about 0.02 in/in and the other scale from zero to maximum strain (b) from this diagram find the modulus of clasticity, the 0.2 percent offset yield strength, the ulti- mate strength, and the percent reduction in area. (c) characterize the material as ductile or brittle. explain your reasoning (d) identify a material specification from table a-20 that has a reasonable match to the data compute the true stress and the logarithmic strain using the data of prob. 2-6 and plot the results on log-log paper. then find the plastic strength coefficient oo and the strain-strengthening exponent m. find also the yield strength and the ultimate strength after the specimen has had 20 percent cold work.

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 09:00

Sobre transformações cíclicas, são feitas algumas afirmações, determine quais estão corretas. i – a variação de energia interna em uma transformação cíclica é nula; ii – o trabalho, em uma transformação cíclica, é sempre positivo; iii – ao completar um ciclo, o gás tem a mesma temperatura com a qual começou a transformação; iv – uma transformação cíclica é, obrigatoriamente, composta de transformações conhecidas, como adiabática, isocórica, etc: a) i e iii b) i e ii c) ii e iii d) i e iv e) iii e iv

Answers: 1

Answer

Physics, 22.06.2019 16:40

On your wedding day your lover gives you a gold ring of mass 3.67 g. 48 years later its mass is 3.44 g. on the average how many atoms were abrated from the ring during each second of your marriage? the atomic mass of gold is 197 u. don't enter units

Answers: 1

Answer

Physics, 22.06.2019 17:10

Which statement best describes the superposition principle? a.) if two in-phase waves arrive simultaneously at a point, their amplitudes add up b.) if two out-of-phase waves arrive simultaneously at a point, their amplitudes add up c.) if two in-phase waves arrive at a point one after another, their amplitudes add up d.) if two out-of-phase waves arrive at a point one after another, their amplitudes adds up

Answers: 2

Answer

Physics, 23.06.2019 04:50

Suppose two stars are located in region a of the h-r diagram shown in the figure below. star c appears much dimmer than star y as seen from earth. which star can be inferred to be nearer to earth and how do you know?

Answers: 1

Answer

You know the right answer?

Aspecimen of steel having an initial diameter of 0.503 in was tested in tension using a gauge length...

Questions