Physics, 05.07.2019 04:30 alegora78

Mopeds (small motorcycles with an engine capacity below 50 cm3) are very popular in europe because of their mobility, ease of operation, and low cost. the article “procedure to verify the maximum speed of automatic transmission mopeds in periodic motor vehicle inspections” (j. of automobile engr., 2008: 1615–1623) described a rolling bench test for determining maximum vehicle speed. a normal distribution with mean value 46.8 km/h and standard deviation 1.75 km/h is postulated. consider randomly selecting a single such moped. a. what is the probability that maximum speed is at most 50 km/h? b. what is the probability that maximum speed is at least 48 km/h? c. what is the probability that maximum speed differs from the mean value by at most 1.5 standard deviations?

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 09:00

Sobre transformações cíclicas, são feitas algumas afirmações, determine quais estão corretas. i – a variação de energia interna em uma transformação cíclica é nula; ii – o trabalho, em uma transformação cíclica, é sempre positivo; iii – ao completar um ciclo, o gás tem a mesma temperatura com a qual começou a transformação; iv – uma transformação cíclica é, obrigatoriamente, composta de transformações conhecidas, como adiabática, isocórica, etc: a) i e iii b) i e ii c) ii e iii d) i e iv e) iii e iv

Answers: 1

Answer

Physics, 22.06.2019 17:30

This chart shows characteristics of three different types of waves. which statement is best supported by the information in the chart? wave x and wave y are mechanical waves, and wave z is an electromagnetic wave. wave x and wave y are electromagnetic waves, and wave z is a mechanical wave. wave x and wave z are electromagnetic waves, and wave y is a mechanical wave. wave x and wave z are mechanical waves, and wave y is an electromagnetic wave.

Answers: 1

Answer

Physics, 22.06.2019 19:40

It may seem strange that the selected velocity does not depend on either the mass or the charge of the particle. (for example, would the velocity of a neutral particle be selected by passage through this device? ) the explanation of this is that the mass and the charge control the resolution of the device--particles with the wrong velocity will be accelerated away from the straight line and will not pass through the exit slit. if the acceleration depends strongly on the velocity, then particles with just slightly wrong velocities will feel a substantial transverse acceleration and will not exit the selector. because the acc

Answers: 1

Answer

Physics, 22.06.2019 22:30

Which is a substance that can be separated by physical means and is not the same throughout

Answers: 2

Answer

You know the right answer?

Mopeds (small motorcycles with an engine capacity below 50 cm3) are very popular in europe because o...

Questions