subject
Physics, 12.07.2019 22:10 sliverx201

Apilot loses control of her drone and it goes into a spiraling freefall toward the ground. assume the position of the drone, relative to the pilot (consider her the 'origin') is given by ) (3sin(rt) 3cos(rt),120-9r), over [0, t,], wheret, is time until impact (t is in seconds and each component is measured in feet) a. find the velocity and acceleration vectors of the plane's trajectory determine the plane's speed at 3 seconds, as well as its downward velocity at that time (note that this is just how fast the drone's height is dropping b. assuming the pilot cannot correct the spin, determine the point on the ground (relative to our origin) where the drone hits. also determine the total distance covered by the spiraling drone (you may need to use technology here) c. assume now, on the other hand, that the drone comes out of its spiral after 8 seconds, but that its path afterward is tangent to its trajectory at that moment. determine how far from the pilot the drone hits the ground d. assume the ground is flat as far as the eye can see (as flat as, the xy-plane)

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 02:10
How is coal extracted from mountaintop removal mines? a. dynamite is used to create underground tunnels where miners go to extract the coal. b. dynamite is used to break apart rocks and then draglines are used to remove the broken rock and reach the coal. c. coal in mountaintops is extracted by digging strips in the landscape to reach the coal. d. placer deposits in mountain river bottoms are removed by
Answers: 2
question
Physics, 22.06.2019 03:10
Athin plate moves between two parallel, horizontal, stationary flat surfaces at a constant velocity of v = 7.5 m/s. the two stationary surfaces are spaced 4 cm apart, and the medium between them is filled with oil whose viscosity is 0.9 nยทs/m2. the part of the plate immersed in oil at any given time is 2 m long and 0.5 m wide. if the plate moves through the mid-plane between the surfaces, determine the force required to maintain this motion. what would your response be if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top surface (h1)? if the plate moves through the mid-plane between the surfaces, the force required to maintain the motion will be n. if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top (h1) surface, the force required to maintain the motion would be n.
Answers: 2
question
Physics, 22.06.2019 11:30
The least penetrating form of radiation is
Answers: 1
question
Physics, 22.06.2019 12:00
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
You know the right answer?
Apilot loses control of her drone and it goes into a spiraling freefall toward the ground. assume th...
Questions
question
Mathematics, 23.08.2019 10:30
question
Mathematics, 23.08.2019 10:30
question
Mathematics, 23.08.2019 10:30
question
History, 23.08.2019 10:30
question
World Languages, 23.08.2019 10:30
Questions on the website: 13722361