Adiffraction grating with 240 lines per mm is used in an experiment to study the visible spectrum of a gas discharge tube. at what angle from the beam axis will the third order peak occur if the tube emits light with wavelength of 511.3 nm?

Determine the critical height h of the water level that causes the concrete gravity dam to be on the verge of tipping over due to water pressure. the density of concrete is ρc = 2.40 mg/m3. suppose that hd = 38 m. hint: work the problem using a 1-m width of the dam.

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

What causes the development of most clouds and precipitation in the atmosphere?