Physics, 18.09.2019 03:30 QUEEN2267

3. this problem deals with the shear stress-shear rate data below from a 6 wt% sodium cellulose sulfate polymer solution in water at 24.5°c: (a) make a plot of viscosity vs. shear rate. label all axes, including units. (b) identify a shear rate range, if any, over which the fluid displays newtonian behavior. (c) identify a shear rate range, if any, over which the fluid displays power law behavior. if so, determine the power law constants (k and n). (d) if this polymer solution is to be used in a process at a shear rate of 5,000 s–1 , estimate its viscosity under these conditions. do you think the estimated value is reliable? briefly explain why or why not.

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 17:00

Adiver named jacques observes a bubble of air rising from the bottom of a lake (where the absolute pressure is 3.50 atm) to the surface (where the pressure is 1.00 atm). the temperature at the bottom is 4.00 ∘c, and the temperature at the surface is 23.0 ∘c.what is the ratio of the volume of the bubble as it reaches the surface (vs) to its volume at the bottom (vb)? if jaques were to hold his breath the air in his lungs would be kept at a constant temperature. would it be safe for jacques to hold his breath while ascending from the bottom of the lake to the surface?

Answers: 1

Answer

Physics, 22.06.2019 19:40

Uranium has two naturally occurring isotopes. 238u has a natural abundance of 99.3% and 235u has an abundance of 0.7%. it is the rarer 235u that is needed for nuclear reactors. the isotopes are separated by forming uranium hexafluoride uf6, which is a gas, then allowing it to diffuse through a series of porous membranes. 235uf6 has a slightly larger rms speed than 238uf6 and diffuses slightly faster. many repetitions of this procedure gradually separate the two isotopes. what is the ratio of the rms speed of 235uf6 to that of 238uf6? express your answer to five significant figures.

Answers: 3

Answer

Physics, 23.06.2019 05:40

Element with 3protons and 5neutrons

Answers: 2

Answer

Physics, 23.06.2019 07:50

In a particular chemical reaction, the energy of the reactants is 30 kj and the energy of the products is 5 kj.   the maximum energy of the system is 40 kj. sketch a potential energy diagram for this reaction. make sure to label the energy of the reactants, the energy of the products, the activation energy, and the enthalpy change for the reaction.

Answers: 2

Answer

You know the right answer?

3. this problem deals with the shear stress-shear rate data below from a 6 wt% sodium cellulose sulf...

Questions