subject
Physics, 27.09.2019 05:20 Laydax1587

suppose car 1 collides with car 2; car 2 was not moving. in an ideal situation with no friction, according to the law of conservation of momentum, what happens to the momentum within this system after the collision?
a) it remains the same.
b) it is greatly reduced.
c) it is slightly reduced.
d) it is slightly increased.

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 18:10
Achild throws a ball with an initial speed of 8.00 m/s at an angle of 40.0Β° above the horizontal. the ball leaves her hand 1.00 m above the ground. how long is the ball in flight before it hits the ground?
Answers: 1
question
Physics, 21.06.2019 18:40
The intensity, or loudness, of a sound can be measured in decibels (db), according to the equation , where i is the intensity of a given sound and is the threshold of hearing intensity. what is the intensity, in decibels, [i(db)], when ? use a calculator. round to the nearest whole number. 8 9 19 80
Answers: 1
question
Physics, 21.06.2019 22:50
Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.
Answers: 2
question
Physics, 22.06.2019 02:50
20. threshold braking in the vehicle's braking system occurs when a. the brake pedal is pushed, heel on floorboard, with full foot pressure. b. the brakes are exerting full braking power, without traction loss. c. the driver begins pushing down the brake pedal, with moderate slowdown. d. the brakes just begin to take hold with a gradual slowdown.
Answers: 3
You know the right answer?
suppose car 1 collides with car 2; car 2 was not moving. in an ideal situation with no friction, ac...
Questions
question
Social Studies, 20.07.2019 02:30
Questions on the website: 13722360