Physics, 01.10.2019 17:10 dominiqueallen23

You have an engine you wish to model using an ideal otto cycle. the engine has 1.5 l displacement (vd = vmax − vmin) and compression ratio of 10.5: 1. at a low load you know 0.55 kj of energy is added to the engine, and the in-cylinder pressure and temperature are 50 kpa and 320 k at the start of the compression stroke. using the air-standard assumptions with variable specific heats and r=0.287, what are the peak cycle temperature and pressure? what is the cycle efficiency, and what would the efficiency of a carnot cycle operating between the same temperature limits be? what is the mean effective pressure (mep) at this operating condition?

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 22:00

What type of light does this light bulb produce most (i.e. at what wavelength does the spectrum have maximum intensity)?

Answers: 3

Answer

Physics, 22.06.2019 12:00

Aboat radioed a distress call to a coast guard station. at the time of the call, a vector a from the station to the boat had a magnitude of 45.0 km and was directed 15.0° east of north. a vector from the station to the point where the boat was later found is = 30.0 km, 15.0° north of east. what are the components of the vector from the point where the distress call was made to point where the boat was found? in other words, what are the components of vector c = b - a?

Answers: 3

Answer

Physics, 22.06.2019 12:30

When a vertical beam of light passes through a transparent medium, the rate at which its intensity i decreases is proportional to i(t), where t represents the thickness of the medium (in feet). in clear seawater, the intensity 3 feet below the surface is 25% of the initial intensity i0 of the incident beam. what is the intensity of the beam "10" feet below the surface? (give your answer in terms of i0. round any constants or coefficients to five decimal places.)

Answers: 2

Answer

Physics, 22.06.2019 18:30

Asled is being held at rest on a slope that makes an angle θ with the horizontal. after the sled is released, it slidesa distance d1 down the slope and then covers the distance d2 alongthe horizontal terrain before stopping. find the coefficient ofkinetic friction μk between the sled and the ground, assumingthat it is constant throughout the trip. find the coefficient of kinetic frictionμk. express your answer in terms of someor all of the variables d1, d2, and θ.

Answers: 1

Answer

You know the right answer?

You have an engine you wish to model using an ideal otto cycle. the engine has 1.5 l displacement (v...

Questions

Physics, 24.12.2020 01:00

What is the correct answer? ...