Aspeedboat is approaching a dock at 25 m/s (56 mph). when the dock is 150 m away, the driver begins to slow down. a) what acceleration must the boat have to come to a stop just as it arrives at the dock? b) if the braking acceleration of the boat has a maximum magnitude of 1.0 m/s^2-, how fast is the boat going when it hits the dock? convert your result to mph. c) if the braking acceleration of the boat has a maximum magnitude of 1.0 m/s^2, at what distance from the dock should the driver have begun slowing down?

a) -2.038 m/s²

b) 40.33 mph

c) 312.5 m

Explanation:

t = Time taken

u = Initial velocity

v = Final velocity

s = Displacement

a = Acceleration

Acceleration of the boat is -2.083 m/s² if the boat will stop at 150 m.

Speed of the boat by when it will hit the dock is 18.03 m/s

Converting to mph

Speed of the boat by when it will hit the dock is 40.33 mph

The distance at which the boat will have to start decelerating is 312.5 m

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

answer;

d. are made mostly of liquid

explanation;

-the general   composition and structure planets includes; they have a thick gas and liquid layer covering a small,solid core. mostly the gases are hydrogen and helium atmosphere and layers of liquid hydrogen. for instance neptune and uranus are examples of the outer planets, they have a core covered by ice and ammonia.

-neptune's atmosphere is hydrogen and helium with a bit of methane so there is no oxygen to breath and the interior is made up of frozen water and ammonia with a rock and iron core. thus, there is no liquid water or solid surface to survive.