Problem 2 (3pts) the horizontal rigid beam abcd is supported by vertical bars (1) and (2) and is loaded at points a by vertical force p = 30 kn. bar (1) is made of aluminum [e = 70 gpa] and has a cross-sectional area of 200 mm2 and a length l1 = 8.0 m. bar (2) is made of steel [e = 200 gpa] and has a crosssectional area of 300 mm2 and a length l2 = 5.0 m. assume dimensions a = 2.5 m, b = 2.0 m, and c = 1.50 m. determine the deflection of the rigid beam (a) at point a and (b) at point d.

the design of a ski jumping suit involves a trade-off between giving the skiers lift to get higher jumps and ensuring the skier does not face a lot of drag before the jump itself. an expansive suit may to lift the skier higher, but at the same time, it will also increase the air resistance. higher air resistance as the skier goes down the slope limits the speed of the jump. a big suit also increases the risk of losing balance or control, especially if there's a strong gust of wind. while technologically enhanced suits a lot, clothing is not the only factor in a ski jumper’s success. gathering speed while skiing down the slope, ensuring good speed on the ramp, and maintaining good body posture and form in the air all contribute to a ski jumper's success.