subject
Physics, 29.10.2019 23:31 cjdieball2106

The strength of the magnetic field within a solenoid is b = 3.2 × 10-2 t (outside the solenoid b = 0). a smaller, single loop is placed in the solenoid parallel to the plane of each loop in the solenoid. the resistance of the solenoid is 5.9 ω, the resistance of the loop is 0.27 ω, the diameter of the solenoid is 0.07 m, and the diameter of the loop is 0.04 m. an emf of 12 v is placed across the ends of the solenoid and the length of the solenoid is 0.4 m.1)what is the total number of turns of the solenoid? n=? turns2)what is the magnitude of the magnetic flux through the loop inside the solenoid (remember, it only has one turn and the normal to the loop is parallel to the axis of the solenoid. flux =? t-m2 3)if the emf across the solenoid is varied so that the current in the solenoid now decreases to zero at a constant rate over a time interval of 8.1 seconds, what is the current through the loop during this time? (if the direction of the induced current in the loop is in the same direction as the current in the solenoid, give your answer as a positive value; if the direction of the induced current in the loop is in the opposite direction compared to the current in the solenoid, give your answer as a negative value.)i =? a

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 07:00
Which statement is best supported by the information in the chart? wave y is moving the fastest. wave x is moving the fastest. all of the waves are moving at the same speed. all of the waves have the same value of wavelengths per second.
Answers: 3
question
Physics, 22.06.2019 12:00
What is the weight of a feather (mass = 0.0001 kg) that floats through earth's and the moon's atmospheres?
Answers: 1
question
Physics, 22.06.2019 14:00
Una carga puntual de 3 x 10-6 c se coloca a 12 cm de una segunda carga puntual de - 1,5 x 10-6 c. calcular la magnitud fuerza eléctrica entre las cargas
Answers: 2
question
Physics, 22.06.2019 18:50
Avertical clean glass piezometer tube has an inside diameter of d = 1 mm and is used to measure pressure in a horizontal pipe carrying water as shown. due to pressure in the pipe, the water at 20c rises into the tube to a height h. if the water pressure in the pipe is p = 500 pa gauge, estimate the height h: (a) without considering surface tension (b) with surface tension (capillary) effects. the contact angle  can be assumed at 30 deg
Answers: 2
You know the right answer?
The strength of the magnetic field within a solenoid is b = 3.2 × 10-2 t (outside the solenoid b = 0...
Questions
Questions on the website: 13722360