Increasing mass causes which of the following?
o a. acceleration and force to increase
o
b. acceleration and force to decrease
o c. acceleration to stay the same and force to
increase
o
d. acceleration to increase and force to stay the
same

During physical science, ms. greene challenged her students to produce an energy transformation. james and jill wrapped a 4-inch nail with a coil of fifty turns of wire. they connected one end of the coil to one terminal of a knife switch. they connected the other terminal of the knife switch to the battery. finally, they connected the end of the coil to the other terminal of the battery. james held the tip of a 1-inch nail near the flat end of the 4-inch nail. jill closed the knife switch quickly and then opened it. the 1-inch nail was pulled toward the 4-inch nail. what is the best explanation of why the nail moved? a) electrical energy was converted to mechanical energy in the 1-inch nail. b) the 4-inch nail became an electromagnet and the magnetic force attracted the 1-inch nail. c) the electric current in the 4-inch nail was converted to mechanical energy in the 1-inch nail. d) the 4-inch nail had a positive charge and the 1-inch nail had a negative charge. opposites attracted.

Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)

Efficiency is the ratio of to for a system a)power in to power in b)power in to power out c) power out to power out d) power out to power in