Ablock is pulled up a ramp inclined at 25 degrees. there is an applied force of 3.2 n, 20 degrees above the plans of the ramp. what is the coefficient of friction? what is the mass of the block?

hints given to us: use the angle and fa to find the sliding force
then use the equivalent triangle to find fn
then use ff and fn to find coefficient of friction.

i am lost at the equivalent triangle.

Atwo-stage air compressor operates at steady state, compression 10m^3/min of air from 100 kpa and 300k to 1200 kpa. an intercooler between the two stages cools the air to 300k at a constant pressure of 350 kpa. the compression processes are isentropic. a) calculate the power required to run the compressor, in kw b) compare the result to the power required for isentropic compression from the same inlet state to the same final pressure.

Consider a one meter long horizontal pipe with a constant 100 cm^2 cross sectional area. water flows rightward into the pipe at x = 0 with flow velocity 02m/sec at every point within the pipe intake area. at x=1, the rightward flow rate is 0.192 m/sec. assume the water is a conserved quantity in the pipe, so there must be a leak (a sink) somewhere in the pipe. 1. compute net volumetric flow of the source if the system to be in equilibrium. 2. now assume the pipe in the problem has no leaks. compute the net volumetric rate of change for the system.

Arope has one end tied to a vertical support. you hold the other end so that the rope is horizontal. if you move the end of the rope back and forth with a frequency of 4 hz, the transverse wave you produce has a wavelength of 0.5 m. what is the speed of the wave in the rope?