Physics, 02.12.2019 19:31 jorgelive5870
Acylindrical rod of brass originally 0.40 in (10.2 mm) in diameter is to be cold worked by drawing. the circular cross section will be maintained during deformation. a cold-worked tensile strength in excess of 55,000 psi (380 mpa) and a ductility of at least 15 %el are desired. further more, the final diameter must be 0.30 in (7.6 mm). explain how this may be accomplished
Answers: 2
Physics, 22.06.2019 05:30
Blank liquids and gases exert a buoyant force on objects placed in them
Answers: 3
Physics, 22.06.2019 09:30
This is important. 1. which of the following is an si base unit for measuring length? (2 points) inch gram meter mole 2. which of the following units for distance is an si unit? (2 points) centimeter foot inch yard 3. which of the following tools should a scientist use to measure an object in meters? (2 points) electronic balance pan balance tape measure thermometer
Answers: 2
Physics, 22.06.2019 11:50
Find the dimensions and area of the largest rectangle that can be inscribed in the upper half of the ellipse. (give your answers in terms of a and b. enter the dimensions as a comma-separated list.)
Answers: 2
Physics, 23.06.2019 04:50
Suppose two stars are located in region a of the h-r diagram shown in the figure below. star c appears much dimmer than star y as seen from earth. which star can be inferred to be nearer to earth and how do you know?
Answers: 1
Acylindrical rod of brass originally 0.40 in (10.2 mm) in diameter is to be cold worked by drawing....
Mathematics, 28.05.2020 19:59
Biology, 28.05.2020 19:59
Mathematics, 28.05.2020 19:59
Mathematics, 28.05.2020 19:59
Mathematics, 28.05.2020 19:59
Mathematics, 28.05.2020 19:59
Mathematics, 28.05.2020 19:59
History, 28.05.2020 19:59
Mathematics, 28.05.2020 19:59
Chemistry, 28.05.2020 19:59