subject
Physics, 02.12.2019 23:31 davelopez979

The magnitude of a component of a vector must be:

a. equal to the magnitude of the vector.
b. greater than or equal to the magnitude of the vector.
c. less than, equal to, or greater than the magnitude of the vector.
d. less than or equal to the magnitude of the vector.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 16:30
Acar accelerates from 5.0 m/s to to 11 m/s at a rate of 3.0 m/s^2. how far does it travel while accelerating? 20m 117m 43m 16m
Answers: 3
question
Physics, 21.06.2019 22:00
In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?
Answers: 2
question
Physics, 22.06.2019 00:00
How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.
Answers: 3
question
Physics, 22.06.2019 17:20
You charge a parallel-plate capacitor, remove it from the battery, and prevent the wires connected to the plates from touching each other. when you increase the plate separation, what happens to the following quantities?
Answers: 1
You know the right answer?
The magnitude of a component of a vector must be:

a. equal to the magnitude of the vec...
Questions
question
Mathematics, 30.04.2021 20:50
question
Mathematics, 30.04.2021 20:50
Questions on the website: 13722362