subject
Physics, 05.12.2019 02:31 tina7659

The movement of tectonic plates in two different locations is shown below:

two blocks labeled location a and location b are shown. at location a the top layer of the block shows two horizontal arrows pointing towards each other. small dunes are shown in the middle between the two arrows. the block labeled b has a vertical line in the middle. on the left of the line there is an arrow pointing down. on the right of the vertical line there is an arrow pointing up

which statement is most likely true?

subduction may occur in both locations.

earthquakes may occur in both locations.

subduction may occur in location a only and a volcanic eruption may occur in location b only.

an earthquake may occur in location a only and a volcanic eruption may occur in location b only.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 23:10
A248-g piece of copper is dropped into 390 ml of water at 22.6 Ā°c. the final temperature of the water was measured as 39.9 Ā°c. calculate the initial temperature of the piece of copper. assume that all heat transfer occurs between the copper and the water. remember, the density of water is 1.0 g/m
Answers: 1
question
Physics, 22.06.2019 10:00
**urgent** roberto plans to use two transformers to reduce a voltage of 120 v to 4 v. he uses a transformer that has 300 coils in the primary winding and 50 coils in the secondary winding. he has four other transformers, as listed in the table. which transformer should roberto use to have an ending voltage of 4 v? a- w b-xc- yd- z
Answers: 1
question
Physics, 22.06.2019 14:30
What is the relationship between the direction of motion of the balloon and the wind currents
Answers: 1
question
Physics, 23.06.2019 10:40
2.which choice most accurately explains what happens to the bonds between atoms when water changes to steam, and what becomes of the energy added during this phase change? when water changes to steam bonds between molecules are created. after reaching the boiling point, energy is used to change bond strength and change the kinetic energy of the atoms. when water changes to steam bonds between molecules break apart. after reaching the boiling point, energy is used to break bonds, but does not affect the kinetic energy of the atoms. when water changes to steam bonds between molecules are created. after reaching the boiling point, energy is used to break bonds, but does not affect the kinetic energy of the atoms. when water changes to steam bonds between molecules break apart. after reaching the boiling point, energy is used to change bond strength and change the kinetic energy of the atoms.
Answers: 1
You know the right answer?
The movement of tectonic plates in two different locations is shown below:

two blocks l...
Questions
question
Mathematics, 01.06.2021 20:10
question
History, 01.06.2021 20:10
question
Mathematics, 01.06.2021 20:10
question
Mathematics, 01.06.2021 20:10
question
Mathematics, 01.06.2021 20:10
question
Arts, 01.06.2021 20:10
Questions on the website: 13722362