Technician a says that the abs electrohydraulic unit can be bled using bleeder screws and the manual method. technician b says that a scan tool is often required to bleed the abs electrohydraulic unit. which technician is correct? a. technician a only
b. technician b only
c. both technicians a and b
d. neither technician a nor b

Why can blue light and yellow light combine to produce white light? question 17 options: they are both primary colors of light. they absorb each other's wavelengths. because blue, yellow, and white are primary colors. they are complementary colors of light.

Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?

(8%) problem 12. a bowling ball of mass mb 3 kg 's rolled down the lane with a velocity ofy-2/ m s lt strikes a single remaining pin mp 0.93 kg head on. after the collision the bowling ball has a velocity (in the same direction) of v2 1.1 m/s. = ▲ 33% part (a) write an expression for the velocity of pin in the horizontal direction after the impact, im ,, 33% part (b) what is the pins speed in ms? 33% part (c) assuming the coefficient of friction s μ,-0.1. how far in meters could the pin slide before stopping if it doesn't topple?