Water flows past a flat plate that is oriented parallel to the flow with an upstream velocity of 0.4 m/s. (a) determine the approximate location downstream from the leading edge where the boundary layer becomes turbulent. (b) what is the boundary layer thickness at this location? assume that the water tempetature is 15.6 oc. use approximate physical properties of some common liquids (si units).

There is a theory that indicates that dinosaurs became extinct when about 65 million years ago, a large asteroid hit the earth surface. dust caused by this collision blocked the sunlight reaching the earth's surface and many forms of life became extinct due to the cold. fearing this threat, how large the radius of an asteroid should you be looking for if the dangerous asteroid size is approximately the same as the one that killed the dinosaurs? available data suggests that about 18% of that asteroid's mass ended up as a dust spread evenly over earth after eventually settling out of the upper atmosphere. about 0.0180 g/cm^2 of dust, which is chemically different than the earth's rock, covered the earth's surface. typical asteroids have a density of about 1.9 g/cm^3. now that we know the size of the asteroid, how much energy was released during impact, assuming all of it was just the kinetic energy of the asteroid right before the impact?

Acave rescue team lifts an injured spelunker directly upward and out of a sinkhole by means of a motor-driven cable. the lift is performed in three stages, each requiring a vertical distance of 11.0 m: (a) the initially stationary spelunker is accelerated to a speed of 4.80 m/s; (b) he is then lifted at the constant speed of 4.80 m/s; (c) finally he is decelerated to zero speed. how much work is done on the 78.0 kg rescue by the force lifting him during each stage

Which configuration would produce an electric current? a) rotate a coil of copper wire between two magnets. b) connect a wire between a copper and zinc strip sitting in a beaker of water. c) connect a wire to the (+) positive end of a battery and the other end to a light bulb. d) connect a wire to the negative end of a battery and the other end to a light bulb.