Astainless steel plate (aisi 316) is part of a low temperature heat-treat oven; the plate has a thickness of 1.00 cm. the stainless steel plate is insulated (on one side only) with foam insulation (k = 0.044 w/m-k) 3.00 cm thick; which in turn is covered on one side only with a layer of hard rubber (k = 0.160 w/m-k) 1.00 cm thick (the composite wall goes: stainless steel/foam insulation/hard rubber). the inside-temperature of the stainless steel plate is measured to be 150.0°c, while the outside of the rubber is exposed to convection, t[infinity] = 25.0°c, h[infinity] = 12.0 w/m^2-k. the plate has dimensions of 2.50 m wide by 3.50 m tall.

a) draw and label a sketch of this system include dimensions, k nown temperatures, etc.
b) draw and completely label the corresponding 1-d steady-state conduction resistor diagram.
c) determine the heat transfer rate through the plate.
d) calculate the temperature at the rubber/foam interface.

5submission this assignment is worth 20 points total. you are required to submit the following by next lab: 1. (3 points) determine the equation for the output angular velocity ω2 = θ˙ 2 as a function of θ1, ω1 = θ˙ 1 and α. you must show all your work to receive credit. 2. (2 points) use the result of problem#1 to plot ω2 over 0 ≤ θ1 ≤ 360deg with ω1 = 360deg/sec. do this for α = {10,30}deg. show the results on the same plot and properly label the axes, title, legend. for this you can use matlab or ms excel. 3. (3 points) determine the equation for the output angular acceleration ω˙ 2 and create a plot similar to the one in problem#2. 4. (10 points) submit plots of the results (ω2 and ω˙ 2) obtained from creo/mechanism and compare them to results of problem#2 and problem#3. note that you should do these comparisons for the two cases with α = {10,30}deg. 5. (2 points) provide a brief explanation of the results. did they match? what are the implications as misalignment angle increases?

Energy can be transformed from one form to another. the diagram shows one such process. which energy transformation is represented in the diagram? nuclear to thermal and radiant nuclear to electrical and chemical chemical to nuclear and radiant chemical to electrical and nuclear

Which describes increasing the efficiency of energy resource