subject
Physics, 02.01.2020 21:31 phil820

Which technology category would not likely be the subject of a standard published by the international electrotechnical commission (iec)?

a. semiconductors
b. solar energy
c. encryption
d. consumer appliances

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 05:00
Does work output exceed work input when a machine is used? a) yes, it does, as machines create energy. b) it depends on the type of machine used. c) no, it doesn’t, as machines are inefficient. d) no, it doesn’t, as machines cannot create energy.
Answers: 1
question
Physics, 22.06.2019 11:00
Arowboat passenger uses an oar to push the boat off the dock by exerting a force of 40n for 3.0s. what impulse acts on the boat.
Answers: 1
question
Physics, 22.06.2019 19:30
Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?
Answers: 3
question
Physics, 23.06.2019 00:00
You are a researcher for a golf club manufacturer. you are given two identical looking cubes of a metal alloy. you are informed that they are made of the exact same material, but one is crystalline, whereas the other is amorphous. it is your job to determine which one is amorphous this one is more stress-resistant and is useful in reinforcing golf clubs. which of the following is the best way to determine which is which? a. determine the density of each cube. the more dense one is the amorphous solid. b. melt both cubes and look for a broader range of melting temperatures. the one that melts over a broader range of temperatures is the amorphous solid. c. determine the density of each cube. the less dense cube is the amorphous solid. d. melt both cubes and measure the range of melting temperatures. the one that melts over a narrower range of temperatures is the amorphous solid.
Answers: 1
You know the right answer?
Which technology category would not likely be the subject of a standard published by the internation...
Questions
question
Mathematics, 10.01.2020 02:31
question
Mathematics, 10.01.2020 02:31
question
English, 10.01.2020 02:31
Questions on the website: 13722359