subject
Physics, 04.01.2020 23:31 brobertson72

Alarge wedge with a mass of 10kg rests on a horizontal frictionless surface, as shown. a block with a mass of 5.0kg starts from rest and slides down the inclined surface of the wedge, which is rough. at one instant the vertical component of the block’s velocity is 3.0m/s and the horizontal component is 6.0m/s. at that instant the velocity of the wedge is:

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 00:00
How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.
Answers: 3
question
Physics, 22.06.2019 09:30
True or false graphs must include scales that increase by the same amount
Answers: 3
question
Physics, 22.06.2019 10:30
The precision of a laboratory instrument is ± 0.05 g. the accepted value for your measurement is 7.92 g. which measurements are in the accepted range? check all that apply. 7.85 g 7.89 g 7.91 g 7.97 g 7.99 g
Answers: 1
question
Physics, 22.06.2019 10:50
Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.
Answers: 3
You know the right answer?
Alarge wedge with a mass of 10kg rests on a horizontal frictionless surface, as shown. a block with...
Questions
question
Computers and Technology, 01.04.2021 23:30
question
Mathematics, 01.04.2021 23:30
question
Mathematics, 01.04.2021 23:30
question
Mathematics, 01.04.2021 23:40
Questions on the website: 13722359