subject
Physics, 04.02.2020 05:40 vildhjap42ges

Afox locates its prey, usually a mouse, under the snow by slight sounds the rodents make. the fox then leaps straight into the air and burrows its nose into the snow to catch its next meal. in your calculations ignore the effects of air resistance. 1) if a fox jumps to a height of 81.0 cm. calculate the speed at which the fox leaves the snow. (express your answer to three significant figures.)

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 22:50
As a car drives with its tires rolling freely without any slippage, the type of friction acting between the tires and the road is 100) a) static friction. b) kinetic friction. c) a combination of static and kinetic friction. d) neither static nor kinetic friction, but some other type of friction. e) it is impossible to tell what type of friction acts in this situation.
Answers: 1
question
Physics, 22.06.2019 00:00
(science)study the following ocean currents map. an ocean currents map is shown. on the map the locations for san diego, california and savannah, georgia are marked. there is a looping current from the north past san diego and a looping current from the south near savannah which statement is most likely correct about the average temperatures in san diego, california as compared to savannah, georgia? it is higher in savannah because of the cool ocean currents from the south. it is higher in savannah because of the warm ocean currents from the north. it is lower in san diego because of the warm ocean currents from the south. it is lower in san diego because of the cool ocean currents from the north.
Answers: 2
question
Physics, 22.06.2019 03:10
Athin plate moves between two parallel, horizontal, stationary flat surfaces at a constant velocity of v = 7.5 m/s. the two stationary surfaces are spaced 4 cm apart, and the medium between them is filled with oil whose viscosity is 0.9 n·s/m2. the part of the plate immersed in oil at any given time is 2 m long and 0.5 m wide. if the plate moves through the mid-plane between the surfaces, determine the force required to maintain this motion. what would your response be if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top surface (h1)? if the plate moves through the mid-plane between the surfaces, the force required to maintain the motion will be n. if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top (h1) surface, the force required to maintain the motion would be n.
Answers: 2
question
Physics, 22.06.2019 09:40
Aturntable a is built into a stage for use in a theatrical production. it is observed during a rehearsal that a trunk b starts to slide on the turntable 10 s after the turntable begins to rotate. knowing that the trunk undergoes a constant tangential acceleration of 0.31 m/s2, determine the coefficient of static friction between the trunk and the turntable.
Answers: 3
You know the right answer?
Afox locates its prey, usually a mouse, under the snow by slight sounds the rodents make. the fox th...
Questions
question
History, 20.09.2020 03:01
question
Mathematics, 20.09.2020 03:01
question
Mathematics, 20.09.2020 03:01
question
Mathematics, 20.09.2020 03:01
Questions on the website: 13722361