19) Two identical grasshoppers jump into the air with the same initial speed and experience no air resistance. Grasshopper A goes straight up, but grasshopper B goes up at a 66° angle above the horizontal. Which of the following statements about these grasshoppers are correct? (There could be more than one correct choice.)
A) At their highest point, both of them have the same amount of gravitational potential energy.
B) At their highest point, both of them have the same amount of kinetic energy.
C) At their highest point, both of them have the same amount of mechanical energy.
D) At their highest point, grasshopper B is moving faster than grasshopper A.
E) At their highest point, grasshopper A has more gravitational potential energy than grasshopper

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

correct it is c.) b b