Physics, 02.03.2020 16:57 rubend7769

Where conventional relays, contactors and switches, which have arcing contacts, are installed in Class I, Division 1 and 2 locations, they must be enclosed in ? .

Answers: 3

Show answers

Another question on Physics

Physics, 21.06.2019 20:00

When using two-wire cable to feed a 240-v appliance that does not require a neutral wire, you should a. mark both ends of the white wire green. b. use the cable as is. c. use only the black wire. d. mark both ends and any exposed area of the white wire black.

Answers: 1

Answer

Physics, 22.06.2019 08:00

Aheat engine running backward is called a refrigerator if its purpose is to extract heat from a cold reservoir. the same engine running backward is called a heat pump if its purpose is to exhaust warm air into the hot reservoir. heat pumps are widely used for home heating. you can think of a heat pump as a refrigerator that is cooling the already cold outdoors and, with its exhaust heat qh, warming the indoors. perhaps this seems a little silly, but consider the following. electricity can be directly used to heat a home by passing an electric current through a heating coil. this is a direct, 100% conversion of work to heat. that is, 19.0 \rm kw of electric power (generated by doing work at the rate 19.0 kj/s at the power plant) produces heat energy inside the home at a rate of 19.0 kj/s. suppose that the neighbor's home has a heat pump with a coefficient of performance of 4.00, a realistic value. note: with a refrigerator, "what you get" is heat removed. but with a heat pump, "what you get" is heat delivered. so the coefficient of performance of a heat pump is k=qh/win. an average price for electricity is about 40 mj per dollar. a furnace or heat pump will run typically 200 hours per month during the winter. what does one month's heating cost in the home with a 16.0 kw electric heater? what does one month's heating cost in the home of a neighbor who uses a heat pump to provide the same amount of heating?

Answers: 2

Answer

Physics, 22.06.2019 13:00

Which of the following correctly describes what happens when an atomic bomb explodes? small pieces of fissionable material are joined and form a body with a mass greater than the critical mass, the relative number of neutrons escaping decreases, and a chain reaction and explosion result. large pieces of fissionable matter are brought together quickly and form a body with a mass smaller than the critical mass, the relative number of escaping neutrons increases, and a chain reaction and explosion result.

Answers: 2

Answer

Physics, 22.06.2019 19:30

Ashot putter releases the shot some distance above the level ground with a velocity of 12.0 m/s, 51.0 ∘above the horizontal. the shot hits the ground 2.08 s later. you can ignore air resistance. how far did she throw the shot?

Answers: 2

Answer

You know the right answer?

Where conventional relays, contactors and switches, which have arcing contacts, are installed in Cla...

Questions