Physics, 09.03.2020 20:18 shaylawaldo11

Give an example of a strain tensor for which there is (a) an increase in volume, (b) a decrease in volume, (c) shear strain but no volume change. (d) which if these strains could result from a P wave, and which result from an S wave

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 11:30

Achlorine atom has 17 protons and 18 neutrons. what is its mass number? what is its atomic number?

Answers: 2

Answer

Physics, 22.06.2019 19:30

Point charges q1=+2.00μc and q2=−2.00μc are placed at adjacent corners of a square for which the length of each side is 1.50 cm . point a is at the center of the square, and point b is at the empty corner closest to q2. take the electric potential to be zero at a distance far from both charges. part a what is the electric potential at point a due to q1 and q2? express your answer with the appropriate units.

Answers: 2

Answer

Physics, 23.06.2019 08:00

Use henry's law and the solubilities given below to calculate the total volume of nitrogen and oxygen gas that should bubble out of 1.7 l of water upon warming from 25 ˚c to 50 ˚c. assume that the water is initially saturated with nitrogen and oxygen gas at 25 ˚c and a total pressure of 1.0 atm. assume that the gas bubbles out at a temperature of 50 ˚c. the solubility of oxygen gas at 50 ˚c is 27.8 mg/l at an oxygen pressure of 1.00 atm. the solubility of nitrogen gas at 50 ˚c is 14.6 mg/l at a nitrogen pressure of 1.00 atm. assume that the air above the water contains an oxygen partial pressure of 0.21 atm and a nitrogen partial pressure of 0.78 atm.

Answers: 2

Answer

Physics, 23.06.2019 10:40

1. study the scenario. the particles in some system are moving around quickly. a few minutes later, the particles are moving, on average, more slowly. how does this change in motion affect the temperature of the system? the temperature of the system did not change. the speed of the particles does not affect temperature, the number of particles affects the temperature.the temperature of the system is lower now than it was initially. faster moving particles result in a higher temperature for the system.the temperature of the system is higher now than it was initially. slower moving particles result in a higher temperature for the system.the temperature of the system did not change. the speed of the particles has no effect on the temperature, only the type of atom affects the temperature.

Answers: 2

Answer

You know the right answer?

Give an example of a strain tensor for which there is (a) an increase in volume, (b) a decrease in v...

Questions