Physics, 09.03.2020 23:51 lejeanjamespete1

To keep the calculations fairly simple, but still reasonable, we shall model a human leg that is 92.0cm long (measured from the hip joint) by assuming that the upper leg and the lower leg (which includes the foot) have equal lengths and that each of them is uniform. For a 70.0 kg person, the mass of the upper leg would be 8.60kg , while that of the lower leg (including the foot) would be 5.25 kg.

(Part A)
Find the x-coordinate of the center of mass of this leg, relative to the hip joint, if it is stretched out horizontally.
xc = m
(Part B)
Find the y-coordinate of the center of mass of this leg, relative to the hip joint, if it is stretched out horizontally.
yc= m
(Part C)
Find the x-coordinate of the center of mass of this leg, relative to the hip joint, if it is bent at the knee to form a right angle with the upper leg remaining horizontal.
xc= m
(Part D)
Find the y-coordinate of the center of mass of this leg, relative to the hip joint, if it is bent at the knee to form a right angle with the upper leg remaining horizontal.
yc= m

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 21:00

In order to place a satellite into orbit, it requires enough fuel to supply the necessary mechanical energy. into what types of mechanical energy does the fuel get transformed?

Answers: 1

Answer

Physics, 22.06.2019 05:50

There are two routes similar in terrain; however, one route has an incline of approximately 28 degrees, and you must decide on which route to take. what is the maximum road grade that your fully loaded ecv can climb?

Answers: 2

Answer

Physics, 22.06.2019 14:20

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.

Answers: 1

Answer

Physics, 22.06.2019 20:00

Choose a realistic problem for which these are the correct freebody diagrams. be sure that the answer that the problem requests is consistent with the diagrams shown. choose a realistic problem for which these are the correct freebody diagrams. be sure that the answer that the problem requests is consistent with the diagrams shown. a 1.0 kg block is placed on top of a 2.0 kg block. a horizontal rope pulls the 2.0 kg block across a frictionless floor with a force of 21.0 n. the coefficient between the two blocks is 0.75. does the 1.0 kg block on top slide?

Answers: 3

Answer

You know the right answer?

To keep the calculations fairly simple, but still reasonable, we shall model a human leg that is 92....

Questions