Technician A says the primary purpose of a thermostat is to cause the engine to warm up as soon as possible. Technician B says the thermostat should be removed from the cooling system only if the engine is overheating. Who is correct?
1. Technician A
2. Technician B
3. Both technician are correct
4. None of the technician is correct

Achild throws a ball with an initial speed of 8.00 m/s at an angle of 40.0° above the horizontal. the ball leaves her hand 1.00 m above the ground. how long is the ball in flight before it hits the ground?

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

The slope of a velocity time graph over any interval of time gives the during that interval