Physics, 14.04.2020 22:03 MaKennaHenry7971

One end of a light uniform rod is attached to a wall by a frictionless hinge. The rod is held in a horizontal position by a wire that runs from the other end of the rod to the wall. The wire has length 2.00 m and makes an angle of 30.0 ° with the rod. A block with mass m is suspended by a light rope attached to the middle of the rod. The transverse fundamental standing wave on the wire has frequency f. The mass m is varied and for each value the frequency is measured. You plot f 1 versus m and find that your data lie close to a straight line with slope 20.4 kg−1⋅s−2. What is the mass of the wire? Assume that the change in the length of the wire when the tension changes is small enough to neglect

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 23:30

To do work, this truck uses energy stored in chemical fuel and an electrical battery. how much total energy does this truck put out?

Answers: 1

Answer

Physics, 22.06.2019 10:20

Assume that a person skiing high in the mountains at an altitude of h = 15100 ft takes in the same volume of air with each breath as she does while walking at sea level. determine the ratio of the mass of oxygen inhaled for each breath at this high altitude compared to that at sea level. assume that the air composition (i.e. % of air that is oxygen) is the same at sea level as it is at 15100 ft.

Answers: 2

Answer

Physics, 22.06.2019 16:50

Calculate the first and second velocities of the car with four washers attached to the pulley, using the formulas v1 = 0.25 m / t1 , and v2 = 0.25 m / (t2 – t1) where t1 and t2 are the average times the car took to reach the 0.25 and the 0.50 meter marks. record these velocities, to two decimal places, in table e.

Answers: 2

Answer

Physics, 22.06.2019 16:50

Consider the growth of a 20-nm-diameter silicon nanowire onto a silicon wafer. the temperature of the wafer surface is maintained at 2400 k. assume the thermal conductivity of the silicon nanowire is 20 wm-1k-1 and all its surfaces including the tip are subjected to convection heat transfer with the coefficient h = 1×105 wm-2k-1 and t∞ = 8000 k. when the nanowire grows to l = 300 nm, what is the temperature of the nanowire tip (t (x =

Answers: 1

Answer

You know the right answer?

One end of a light uniform rod is attached to a wall by a frictionless hinge. The rod is held in a h...

Questions