The basic barometer can be used to measure the height of a building. If the barometric readings at the top and at the bottom of a building are 675 and 695 mmHg, respectively, Final PDF to printer cen22672_ch01_001-050.indd 42 11/03/17 07:10 AM 42 INTRODUCTION AND BASIC CONCEPTS determine the height of the building. Take the densities of air and mercury to be 1.18 kg/m3 and 13,600 kg/m3 , respectively.

Agas initially at p1 = 1 bar and occupying a volume of 0.5 liter is compressed within a piston–cylinder assembly to a final pressure p2 = 4 bar. (a) if the relationship between pressure and volume during the compression is pv = constant, determine the volume, in liters, at a pressure of 3 bar. (b) repeat for a linear pressure–volume relationship between the same end states. reference

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Using a wheel and axle, a farmer is trying to lift a bucket of water from the bottom of a well. the larger wheel has a radius of 40 cm compared to the axle that has a radius of 10 cm. if a bucket of water is 50 n, then how much effort is required to raise it? 12.5 n 200 n 2 n 500 n