subject
Physics, 05.05.2020 05:38 Svetakotok

1. The workpart in a turning operation is 88 min in diameter and 400 mm long. A feed of 0.25 mm/rev is used in this operation. If cutting speed is 3.5 m/s, the too should be changed in every 3 workparts, but if the cutting speed is 2.5 m/sec, the tool can be used to produce 20 pieces between the tool changes. Determine the cutting speed that will allow the tool to be used for 50 parts between tool changes.

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 22:40
Consider two metallic rods mounted on insulated supports. one is neutral, the other positively charged. you bring the two rods close to each, but without contact, and briefly ground the the neutral rod by touching it with your hand. show answer correct answer what would be resulting charge (if any) on the initially neutral rod
Answers: 1
question
Physics, 22.06.2019 08:30
A17,250 kg rocket is pushed with a thrust of 6,450,284 n. what is the acceleration of the rocket?
Answers: 1
question
Physics, 22.06.2019 10:30
Apulley with mass mp and a radius rp is attached to the ceiling, in a gravity field of 9.81 m/s2 and rotates with no friction about its pivot.
Answers: 3
question
Physics, 22.06.2019 10:30
J. j. thomson’s experiment disproved the theory that an atom
Answers: 3
You know the right answer?
1. The workpart in a turning operation is 88 min in diameter and 400 mm long. A feed of 0.25 mm/rev...
Questions
Questions on the website: 13722361