Out of
A bolted butt joint is shown. The diameter of bolts is 2 cm. The width and the thickness of the plates are as shown in the figure. Determine
the safe load Q that can be applied to the joint.
The allowable stresses are as follows:
Bolts: Allowable shear stress for bolts = 0.96 Ucm2
Plates: Allowable bearing stress for plates = 1.5 t/cm2
Allowable tensile stress for plates = 1.4 cm2
Plate of thickness 1.5 cm
Choose...
Failure due to bolt
shear (ton)
Bearing failure of
bolt or plate
(compression
failure) (ton)
Choose
:
Splice plates of
thickness 0.8 cm
Plate tensile (ton)
Choose
3 633 6 3 cm
ТАст
+
Finish attempt

2.22/3.33 points | previous answers tamucolphysmechl1 4.pre.002. ask your teacher my notes question part points submissions used on a frictionless air track, a blue glider with mass 0.200 kg is moving to the right with a speed of 8.00 m/s. it strikes a red glider that has mass 0.600 kg and that is initially at rest. after the collision, the blue glider is moving to the left with a speed of 2.40 m/s. (a) what are the magnitude and direction of the velocity of the red glider after the collision? magnitude 3.33 m/s correct: your answer is correct. direction correct: your answer is correct. (b) is this collision elastic?

The crank oa rotates in the vertical plane with a constant clockwise angular velocity ω0 of 5.6 rad/s. for the position where oa is horizontal, calculate the force under the light roller b of the 10.6-kg slender bar ab.

Me with this and you will be marked brainliest